Debottlenecking and process improvement for emission control systems.

We support owners and operators in the debottlenecking and performance improvement of emission control systems, always focused on compliance with the latest emission limits, operational friendliness and minimal downtime. Decades of field experience, combined with independent engineering.

Home
Expertise

Debottlenecking & Process Improvement

Higher capacity

Better reliability

Minimal downtime

A structured, low-risk path to higher performance.

We optimise and upgrade all types of emission control equipment, from wet gas scrubbers and thermal oxidation systems to vapour recovery units, step by step and with tangible results.

01
Improvement Options

Development and comparison of technical improvement options, so you can choose on performance, cost and risk.

Learn more

02
Heat and Mass Balance Studies

We quantify where the system is limited: flows, concentrations, temperatures and energy use under real operating conditions.

Learn more

03
Technology Selection & Reconfiguration

Selection of additional or alternative technology, or reconfiguration of the existing system to meet new limits.

Learn more

04
Functional Design Specifications

An FDS that defines the modified control and operating philosophy as the basis for automation changes.

Learn more

05
Training & Operational Manuals

Updated manuals and training so operators can run the improved system with confidence.

Learn more

06
Start-Up & Optimisation Support

On-site support during restart and fine-tuning until the improved performance is proven.

Learn more

Not sure where the bottleneck is?

A short assessment of your operating data and measurements often pinpoints the limiting step before any hardware is changed.

We improve

Scrubbers

Thermal oxidisers

VRUs

Activated carbon

02 / Where systems get stuck

Existing systems pushed to their technical limits.

Stricter emission limits, higher throughput, new products or ageing equipment can push an existing emission control system beyond its design envelope. Debottlenecking finds the rate-limiting step and resolves it, often at a fraction of the cost of a new system.

Every change is checked against permit limits, ATEX requirements and safety margins, so higher capacity does not come at the expense of compliance.

Higher capacity, better reliability and sustained emissions compliance.

Step by step, measurable.

We improve existing treatment systems with a step-by-step approach that delivers tangible results.


01

Diagnose

Measurements, data review and balances identify the real constraint.


02

Improve

Options are compared and the most effective one is engineered.


03

Prove

Start-up and optimisation support until the improvement is confirmed.

Is your emission control system holding back production?

04 / FAQ

Questions we often discuss with plant teams

The first technical conversation can usually identify the most important data gaps and feasible pathways.

Still have questions about your process?

Share the application and your main concern — we’ll map the most useful next step together.

Which systems can you debottleneck?

All types of emission control equipment, including wet gas scrubbers, thermal and catalytic oxidisers, activated carbon systems and vapour recovery units, regardless of make.

Do we need to replace the system to meet new limits?

Not always. Reconfiguration, control upgrades or adding a polishing step can often bring an existing system into compliance at lower cost than a new installation.

How do you keep downtime to a minimum?

Changes are planned around your production schedule, prepared in detail beforehand and supported on site during restart and optimisation.

Do you also handle measurements?

Yes. Where needed we plan targeted measurement campaigns to establish the baseline and verify the result after improvement.

Contact

Start with your process

Not sure which VOC solution fits? Share the application and your main concern. We’ll use the first discussion to understand the process, available data and the most useful next step.

Broekstraat 6, 5292 ND Gemonde, NL

hello@bmprocess.nl

+31 6 42173663

Request a technical discussion

Response within one working day

Great! We’ve received your information.

Contact

Trusted by Industry Leaders

Not sure where to start? Talk to an engineer directly.